How I Mount and Store all My Plain Raw Rubber Stamps Tutorial

Hi everyone! It's Angela here and I wanted to share with you a tutorial on how I mount my plain raw rubber Sweet Pea's. First I cut out all my images then I turn them upside down. I did all my newest images outside as the weather was just too pretty to stay inside.


I use Aleene's 'TACK-IT' Over & Over glue. You can purchase it at Michaels that's were I got mine. You can probably find it on some on-line stores. I know Joann and Hobby Lobby carries the Aleene's glue but NOT the TACK- IT Over & Over glue. And that's what you need. Just to warn you this glue is VERY, VERY sticky. So keep a wet rag handy. Make sure you shake the glue up GOOD or it will be watery.

You will need a brush to apply the glue over the rubber. Any small to med. paint brush will work.

I just squeeze a small amount on the back of my stamps and brush all over the rubber, you may need to add more glue or less depending on the amount you need.

After you have applied the glue all over in even coats let them dry for at least an hour or longer just to make sure they are completely dry. When dry they will be sticky and you can attach then to your acrylic blocks if you want to stamp right away or they are ready for storage.

And I am going to show you what I use to store them on/in.

I use these clear plastic storage containers called Scrap Onizer's. I purchased mine at Unity Stamps but you can Google them and find them at other places. This was the cheapest place I found them at. You will also need to purchase the clear folders to attach them to. They come just like any other folder, but to get the best use out of them I cut them in half where they bend over. That way I have 2 pieces and I can lay them on top of each other. Here is a picture of one of the folders before I cut it in half.

After I have cut them in half they are ready to be attached to the clear folder and ready for storage. When you want to use one, just pull it off the folder, stamp, clean and stick back.

Here's a picture to show you where I started sticking my stamps to the folder. And you can see glue where the light is hitting the dry glue.

I turned the folder up side down to show you they are stuck and not going anywhere.

I also use the bottom of the storage container and stick some of my stamps to it. As it is made out of the same stuff. Then you can just start stacking up the folder halves on top of it.

Here is a picture to show you the container from the side. They are only about an 1" to 1.5" thick and can be stood up like a book. I have tried alot of different way's to store and attach my plain rubber stamps and this is by far the best to me that I have tried. I even use these container to storage my foam mounted rubber stamps. These storage containers works great for both. And the Aleene's TACK IT Over & Over glue is under $5 a bottle and this bottle goes a long way.

Well I just wanted to show you how I store my stamps and how I attach them to my acrylic blocks for stamping. I never have to worry about losing a stamp either and I can see through the containers. I also take a marker and write the stamp company on the spine of my containers. Here is a picture of how they look stood up on my shelf.